Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide

Reference 20Transient Withstand CapabilityCAUTIONMaximum input voltage at analog inputsCAT I 300 Vrms, 400 Vpk; transient overvoltage 1.6 kVpkWith 10073C 10:1 probe: CAT I 500 Vpk, CAT II 400 VpkWith N2862A or N2863A 10:1 probe: 300 VrmsCAUTIONMaximum input voltage at digital channels±40 V peak CAT I; transient overvoltage 800 VpkEnvironmental ConditionsEnvironmentAmbienttemperatureHumidityAltitudeOvervoltageCategoryPollution DegreePollution DegreeDefinitionsIndoor use only.Operating 0 C to +55 C; non-operating –40 C to +71 COperating: Up to 80% RH at or below +40 C. Up to 45% RH up to +50 C.Non-operating: Up to 95% RH up to +40 C. Up to 45% RH up to +50 C.Operating and non-operating to 4,000 m (13,123 ft)This product is intended to be powered by MAINS that comply to OvervoltageCategory II, which is typical of cord-and-plug connected equipment.The InfiniiVision 2000/3000 X-Series oscilloscopes may be operated inenvironments of Pollution Degree 2 (or Pollution Degree 1).Pollution Degree 1: No pollution or only dry, non-conductive pollution occurs.The pollution has no influence. Example: A clean room or climate controlledoffice environment.Pollution Degree 2. Normally only dry non-conductive pollution occurs.Occasionally a temporary conductivity caused by condensation may occur.Example: General indoor environment.Pollution Degree 3: Conductive pollution occurs, or dry, non-conductivepollution occurs which becomes conductive due to condensation which isexpected. Example: Sheltered outdoor environment.Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide 253