HORN-System DR - Horn USA, Inc.

TROUBLESHOOTING SOLUTIONSRFaultSurface quality unsatisfactoryRemedy1. Check insert wear2. Reduce run-out error and use compensation holder,check cutting data (pages R32-R33)3. Use tool with internal coolant supply4. Increase coolant mixRetention marks in hole1. Reduce run-out error and use compensation holder2. Check insert wear (build-up edges)3. Reduce depth of cut4. Use a sharper geometry5. Reduce pull back feedReamer jams1. Reduce coolant mix2. Increase depth of cut3. Check insert wear4. Change chamfer angleHole too small1. Change insert2. Reduce coolant mix3. Increase depth of cut4. Increase cutting speed5. Reduce feed rateIn the UNITED STATES call us toll free1 - 888 - 818 HORNR35