2 - Big Ass Fans

12’–24’ BASIC6 Hanging the Fan1. Attach extension tube (to upper yoke)Fasten the extension tube to the upper yoke with the Extension TubeHardware as shown. Ensure the extension tube is hanging plumb to theground, and then tighten the hardware so that it is snug, but not fullytightened.Note: If the mounting structure requires a non-standard length ofExtension Tube Hardware (BAF-Supplied):a. (2) 1/2-13 x 4-1/2” GR 8 Boltb. (4) 1/2’’ Flat Washerc. (2) 1/2-13 Nylock Nutcbba2. Secure safety cableThe safety cable is a crucial part of the fan and must be installed correctly. If you have questions, call CustomerService at 1-877-BIG-FANS for assistance.Note: If your fan installation includes an extension tube, the safety cable is already attached to the extension tube. If you are mountingthe fan without an extension tube, the safety cable is packed separately.I-Beam mountSecure the safety cable by wrapping itaround the I-beam and connecting thelooped ends with the shackle as shown.The cable must be drawn tightly aroundthe I-beam, leaving as little slack aspossible. If possible, the shackle shouldbe on the topside of the I-beam. Securelytighten the shackle.Proceed to step 3.Angle iron mount(with extension tube)Secure the safety cable by wrapping itaround the angle irons and connecting thelooped ends with the shackle as shown.The cable must be drawn tightly aroundthe angle irons, leaving as little slack aspossible. The shackle should be on thetopside of the angle irons if possible.Securely tighten the shackle.Proceed to step 3.Angle iron mount(no extension tube)Route the cable through the motor frameand around the angle irons as shown.Connect the looped ends of the cable withthe shackle. The cable must be drawntightly around the angle irons, leavingas little slack as possible. The shackleshould be on the topside of the angle ironif possible. Securely tighten the shackle.ShackleWWW.BIGASSFANS.COM ©2012 DELTA T CORP. DBA BIG ASS FAN ALL RIGHTS RESERVED