Camano Wood Stove Owner's Manual.pdf

More documents

Recommendations

Info

20 Operating Your ApplianceAdjusting the Burn RateUse the air control slider to control the burn rate of the stove. See the illustration below for details.Approximate Air Control SettingsOvernight BurnMedium BurnMedium High BurnHigh BurnFully out to 9/32" open9/32" to 5/16" open5/16" to 7/16" open7/16" to full inThe air control becomes hot during operation - use gloves or a tool to prevent burns.Ash RemovalASHESThe air control may take several minutes to influence the burn rate. When making adjustments, youmay wish to let the stove burn for 10 minutes to gauge performance.Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashesshould be placed on a noncombustible floor or on the ground, away from all combustiblematerials, pending final disposal. If the ashes are disposed of by burial in soil or otherwise locallydispersed, they should be retained in the closed container until all cinders have thoroughlycooled.© Travis Industries 100-01252_000 4101004
Optional Blower OperationOperating Your Appliance 21The blower will turn on once the stove is up to temperature. This is typically 15 to 30 minutes afterstarting the fire. Follow the directions below to alter the blower speed.OFFTurn the dial all the way counterclockwiseuntil it clicks off.LOBLOWERCONTROLThe high position is all the way counterclockwise,without clicking off.LOOFF HIHIGHBLOWERCONTROLTurn the dial all theway clockwise. LO LOWOFF HIOFF HIBLOWERCONTROLThe blower may be used to affect heat output (i.e.: to reduce heat output, turn the blower down).Route the power cord in a location where it will not come in contact with the appliance or become hot.Re-Loading the <strong>Stove</strong>Follow the directions below to minimize smoke spillage while re-loading the stove.1 Open the air control all the way (push it in).2 Open the door slightly. Let the airflow inside the firebox to stabilize before opening the doors fully.3 Load wood onto the fire.Overnight BurnThis stove is large enough to accommodate burn times up to eight hours. Follow the steps below toachieve an overnight burn.1 Move the air control to high burn and let the stove become hot (burn for approximately 15 minutes).2 Load as much wood as possible. Use large pieces if possible.3 Let the stove burn on high for 15 minutes to keep the stove hot, then adjust the air control to low.4 In the morning the stove should still be hot, with embers in the coal bed. Stir the coals and loadsmall pieces of wood to re-ignite the fire, if desired.Differences if chimney height and draft may lower overall burn times.Normal Operating SoundsCreaks and Clicks:The steel may creak or click when the stove heats upand cools down - this is normal.Blower Sounds:The blower will make a slight "humm" as itpushes air through the stove.Hint:Make sure the leveling bolts on legs are extended -preventing the hearth from amplifying any vibrations.© Travis Industries 100-01252_000 4101004
Page 1 and 2: “CamanoWood StoveOwner's Manual
Page 4 and 5: 4 Safety PrecautionsThe viewing doo
Page 6 and 7: 6 Features & SpecificationsInstalla
Page 8 and 9: 8 Stove Installation (for qualified
Page 10 and 11: 10 Stove Installation (for qualifie
Page 16 and 17: }16 Stove Installation (for qualifi
Page 18: 18 Operating Your ApplianceSafety N
Page 24 and 25: 24 Maintaining Your ApplianceFailur
Page 26 and 27: 26 Maintaining Your ApplianceYearly
Page 28 and 29: 28 Maintaining Your ApplianceFirebo
Page 30 and 31: 30 Limited 7 Year WarrantyTo regist
Page 32 and 33: CM32 Listing LabelListing LabelHOT
Page 34: 34 IndexAir Control ...............

Camano Wood Stove Owner's Manual.pdf

Create successful ePaper yourself

Delete template?

Save as template?