EX500-GPR1

RWiring (continued )For GW unit – Input unit manifold configurationDisplay/Switch SettingSettings for displayTo the communication connector of Input unit, connect the branch cable with M12connector from GW unit.GW unitP R O F IINB U SBUSOUTRUNSOLBFDIAGATEWAY UNITEX500 SERIESCOM A COM B COM C COM DBranch cablewith M12 connectorInput unit manifoldType, pin layout and connection diagram of the branch cable with M12 connector ( EX500-AC - )M1248L65216DisplayRUNSOLBFDIACOM ALights on: Power for Input and controlling GW/SI is supplied.Lights off: Power for Input and controlling GW/SI is not supplied.Lights on: Power is supplied to solenoid valves/output at specified voltage.Lights off: Power is not supplied to solenoid valves/output at specifiedvoltage.( Voltage dropped to lower than 20V )Lights on: PROFIBUS-DP communication is abnormal.Lights off: PROFIBUS-DP communication is normal.Lights on: DIA is abnormal.Lights off: DIA is normal.DescriptionLights on: COM A is receiving data.Lights off: COM A has no received data.14.9Straight Connector TypeEX500-AC-SSPSM12COM BCOM CLights on: COM B is receiving data.Lights off: COM B has no received data.Lights on: COM C is receiving data.Lights off: COM C has no received data.M12M12COM DLights on: COM D is receiving data.Lights off: COM D has no received data.28.331.3631.332.3NOTEWhen connecting manifold valve only without connecting Input unit manifold, LEDs ofCOM A - D do not light. To make them light, connect a terminal plug to the unusedconnector of SI unit ( "C1" or "0" ).LAngle Connector TypeEX500-AC -SAPAL=300, 500, 1000, 3000, 5000 (mm)16 17