EX500-GPR1

EX9 Series General Purpose Output Block Part Names (continued ) Mounting2. EX9-PE1The mounting and removing methods of each SI unit are as shown below.VQC seriesSupply/exhaust block assembly,end plate R, power block, or otherEX9 series general purpose output blockNo.Part nameSI unit forgeneral purposeoutput block( EX500-Q 02 )Dimensions ( unit: mm )1. EX9-OET1/EX9-OET2/EX9-OEP1/EX9-OEP22. EX9-PE1Application1 Power supply connector Unused2 Power input connector Supplies power for output devices. ( Note1 )3 Power LEDIndicates the power supply status. ( Note2 )Note1: For wiring method, refer to subsection "Wiring" ( page 34 ) of section "EX9 SeriesGeneral Purpose Output Block" in this manual.Note2: For display, refer to subsection "Display" ( page 37 ) in section "EX9 Series GeneralPurpose Output Block" in this manual.M3 18 : 2 pcs.( Hexagon socket headcap screw ( with spring washer ))Power block or EX9 seriesgeneral purpose output blockTie-rod: 4 pcs.SI unit for general purposeoutput block ( EX500-Q 02 )NOTEHolding with hand so that there will be no gap between units and tighten the bolts.Be sure to tighten each bolt by specified tightening torque.( Tightening torque: 0.6Nm )Dimensions when general purpose output block is connected13PWRCOMPWRL1L2L300000000661111111121.259.843.272.622.22126.721.259.843.280.322.2PWR2126.7L dimensions32 33EX500seriesPWR1.5Mounting hole for:M4 placesNo. of output block stations 1 2 3 4 5 6 7 8L1 [mm] 83 104 125 146 167 188 209 230L2 [mm] 72 93 114 135 156 177 198 219L3 [mm] 67 88 109 130 151 172 193 214NoteThe above dimensions show those when one unit of power block ( width: 21mm ) iscombined. For details, refer to the instruction manuals, technical data, etc. of EX9series general purpose output block.