25-Size Float Set - E-flite

More documents

Recommendations

Info

5. Attach the ventral fin mount using three 2mm x12mm sheet metal screws. 6. Remove the bottom 1/8" (3mm) of covering fromthe ventral fin using a hobby knife.10
7. Attach the ventral fin to the mount using 6-minuteepoxy. Make sure the fin is in line with the verticalcenterline of the fuselage.Linkage InstallationRequired Parts• Fuselage w/floats • Nylon bracket• Steering arm • 5/32" wheel collar• 3mm setscrew (2) • Pushrod connector (2)• Tie wrap• Half brass strap• Full brass strap (3) • Connector backplate (2)• Rudder shaft assembly• 3mm x 12mm sheet metal screw (4)• 29 3 / 4 " (755mm) pushrod cable• <strong>25</strong> 3 / 4 " (655mm) pushrod tube• 2mm x 10mm sheet metal screw (7)Required Tools and Adhesives• Phillips screwdriver • Hobby knife• Pliers• Threadlock• Drill• Drill bit: 5/64" (2mm)• Hex wrench: 1.5mm, 3/32”11
Page 7 and 8: Float Installation (J-3 Cub)Require
Page 9: 4. Attach the floats using the four
Page 13 and 14: 3. Enlarge the middle hole in the s
Page 15 and 16: 7. Use a tie wrap to attach the pus
Page 17 and 18: Float Installation (Ultra Stick 25e
Page 19 and 20: 4. Use a file or rotary tool to mak
Page 21 and 22: 1. Attach a nylon bracket to the re
Page 23 and 24: 5. With the pushrod cable inside th
Page 25 and 26: 9. Position the water rudder parall
Page 27 and 28: Landing on water is very similar to
Page 29 and 30: 2006 Official AMA National Model Ai
Page 31 and 32: Notes31

25-Size Float Set - E-flite

Create successful ePaper yourself

Delete template?

Save as template?