25-Size Float Set - E-flite

More documents

Recommendations

Info

5. With the pushrod cable inside the pushrod tube,attach the tube to the float using a full brass strapand two 2mm x 10mm sheet metal screws. Theend of the pushrod tube is 1 1 / 2 " (38mm) fromthe end of the float. 6. Use two full brass straps and the half brass strapto attach the pushrod tube to the bottom of thefuselage. Leave the straps slightly loose so it canbe moved around for the next step.Note: These straps are secured onto thecrossbraces on the bottom of the fuselage.14
7. Use a tie wrap to attach the pushrod tube to thelanding gear. Slide the tube as necessary. Onceattached, go back and tighten the screws for thebrass straps. 8. With the rudder centered, secure the pushrodcable using a 3mm setscrew. Place the steeringarm parallel with the end of the float andsecure the cable at the steering arm end usinga 3mm setscrew.15
Page 7 and 8: Float Installation (J-3 Cub)Require
Page 9 and 10: 4. Attach the floats using the four
Page 11 and 12: 7. Attach the ventral fin to the mo
Page 13: 3. Enlarge the middle hole in the s
Page 17 and 18: Float Installation (Ultra Stick 25e
Page 19 and 20: 4. Use a file or rotary tool to mak
Page 21 and 22: 1. Attach a nylon bracket to the re
Page 23 and 24: 5. With the pushrod cable inside th
Page 25 and 26: 9. Position the water rudder parall
Page 27 and 28: Landing on water is very similar to
Page 29 and 30: 2006 Official AMA National Model Ai
Page 31 and 32: Notes31

25-Size Float Set - E-flite

Create successful ePaper yourself

Delete template?

Save as template?