25-Size Float Set - E-flite

More documents

Recommendations

Info

9. Position the water rudder parallel to the rudderof the aircraft. It may be necessary to loosen thesetscrew at the steering arm to do so. 10. Test the operation of the water rudder with theaircraft rudder. The water rudder will move leftwhen the aircraft rudder moves left, and rightwhen the aircraft rudder moves right. 11. Adjust the water rudder to move up and downby tightening or loosening the 4-40 sockethead screw on the rudder shaft. The waterrudder should be able to deflect up if it hits anobstruction in the water. 12. Now that your floats have been installed, youMUST verify that the Center of Gravity of yourmodel is still correct. Use the Center of Gravityprovided in the manual included with yourparticular aircraft.16
Float Installation (Ultra Stick 25e)Required Parts• Fuselage• Landing gear• 3mm setscrew (4)• Nylon bracket (4)• 4-40 x 1/2" socket head screw (3)• 5/32" wheel collar (4)• 3mm x 12mm sheet metal screw (16)Required Tools and Adhesives• Phillips screwdriver • File or rotary tool• Threadlock• Hobby knife• Hex wrench: 3/32"Note: The Ultra Stick 25e comes with thenecessary landing gear mounts for theinstallation of the floats. You will also find 4molded 3.5mm spacer blocks in the Ultra Stick25e kit which will be used when mounting thefloat mounts onto the floats. Use these parts inaddition to the float hardware to complete theinstallation. 1. Locate the holes on the fuselage for the rearlanding gear. These are located behind the airexit on the fuselage. Use a hobby knife toremove the covering. Attach the landing gearto the fuselage using three 4-40 x 1/2" sockethead screws.17
Page 7 and 8: Float Installation (J-3 Cub)Require
Page 9 and 10: 4. Attach the floats using the four
Page 11 and 12: 7. Attach the ventral fin to the mo
Page 13 and 14: 3. Enlarge the middle hole in the s
Page 15: 7. Use a tie wrap to attach the pus
Page 19 and 20: 4. Use a file or rotary tool to mak
Page 21 and 22: 1. Attach a nylon bracket to the re
Page 23 and 24: 5. With the pushrod cable inside th
Page 25 and 26: 9. Position the water rudder parall
Page 27 and 28: Landing on water is very similar to
Page 29 and 30: 2006 Official AMA National Model Ai
Page 31 and 32: Notes31

25-Size Float Set - E-flite

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?