25-Size Float Set - E-flite

More documents

Recommendations

Info

Note: One float has holes drilled in the aft endfor the rudder bracket. This float is mounted onthe same side as the rudder linkage.Linkage InstallationRequired Parts• Fuselage w/floats • Nylon bracket• Steering arm • 5/32" wheel collar• 3mm setscrew (4) • Pushrod connector (2)• Rudder shaft assembly • Tie wrap• Full brass strap (3) • Connector backplate (2)• 3mm x 12mm sheet metal screw (4)• 29 3 / 4 " (755mm) pushrod cable• <strong>25</strong> 3 / 4 " (655mm) pushrod tube• 2mm x 10mm sheet metal screw (6)Required Tools and Adhesives• Phillips screwdriver • Hobby knife• Pliers• Threadlock• Drill• Drill bit: 5/64" (2mm)• Hex wrench: 1.5mm, 3/32”20
1. Attach a nylon bracket to the rear of the floatusing four 3mm x 12mm sheet metal screws. 2. Place a 5/32" wheel collar in the center of thenylon bracket. Slide the rudder assembly throughthe nylon bracket and the wheel collar. Secure thesteering arm at the top and the wheel collar using3mm setscrews.Note: Remember to use threadlock on .both setscrews.21
Page 7 and 8: Float Installation (J-3 Cub)Require
Page 9 and 10: 4. Attach the floats using the four
Page 11 and 12: 7. Attach the ventral fin to the mo
Page 13 and 14: 3. Enlarge the middle hole in the s
Page 15 and 16: 7. Use a tie wrap to attach the pus
Page 17 and 18: Float Installation (Ultra Stick 25e
Page 19: 4. Use a file or rotary tool to mak
Page 23 and 24: 5. With the pushrod cable inside th
Page 25 and 26: 9. Position the water rudder parall
Page 27 and 28: Landing on water is very similar to
Page 29 and 30: 2006 Official AMA National Model Ai
Page 31 and 32: Notes31

25-Size Float Set - E-flite

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?