25-Size Float Set - E-flite

More documents

Recommendations

Info

2. Remove the wheels and wheel collars from themain gear. 3. Attach two of the brackets and float mounts toeach float using eight 3mm x 12mm sheet metalscrews. Each float uses two brackets and two floatmounts, so you'll install eight pieces in all.18
4. Use a file or rotary tool to make a flat on the topof each of the four axles. 5. Attach the floats using the four 5/32" wheelcollars and four 3mm setscrews. Make sure to usethreadlock when tightening the setscrews onto theflats made in the previous step.19
Page 7 and 8: Float Installation (J-3 Cub)Require
Page 9 and 10: 4. Attach the floats using the four
Page 11 and 12: 7. Attach the ventral fin to the mo
Page 13 and 14: 3. Enlarge the middle hole in the s
Page 15 and 16: 7. Use a tie wrap to attach the pus
Page 17: Float Installation (Ultra Stick 25e
Page 21 and 22: 1. Attach a nylon bracket to the re
Page 23 and 24: 5. With the pushrod cable inside th
Page 25 and 26: 9. Position the water rudder parall
Page 27 and 28: Landing on water is very similar to
Page 29 and 30: 2006 Official AMA National Model Ai
Page 31 and 32: Notes31

25-Size Float Set - E-flite

Create successful ePaper yourself

Delete template?

Save as template?