Owner's Guide - DirectedDealers.com

More documents

Recommendations

Info

Charging the BatteryPlug in the USB charger (alternately a standard mini USB cableconnected to any standard USB port on any laptop or desktopcomputer can also be used (cable not included). the battery icon flash. Note: If the battery has been severely discharged all remote functionsare disabled for a short charge period. The battery status outline flashes mulatedenough charge for functionality, the LCD icons initialize witha beep sound, the battery status outline stops flashing and the remote Warning! The temperature range over which thebattery can be charged is 0ºC TO 45ºC (32ºFTO 113ºF). Charging the battery at temperaturesoutside this range may cause severe damage to Low battery indicatorWhen the batteries are low on the 2-way remote it emits two groups ofbeeps, the battery icon flashes and low battery is indicated, the alarmthen emits an additional chirp upon disarming of the alarm to let youknow its time to change the battery. When the battery is low on the1-way remote, the remote responds the same way audibly.Note: alarm to emit any additional chirps during disarm. Ask your authorizeddealer if you have any questions.12 © 2008 Directed Electronics. All rights reserved.
Battery Replacement power is returned the remote control is ready for use. Multi-car control capabilityYou can operate the 2-way remote control system for two cars, with fullcommand capability for both vehicles.To change the Car to be operated:Two Way Remote1. button for 3 seconds or until the remote beeps.The or 2.displayed.Change car: While in this mode press the button to switchbetween cars and the or icon changes accordinglyindicating which car the remote currently operates.3. Select the car you want to operate and then press any commandto operate the system. The selected car remains selected until thesetting is changed.One Way Remote1. Press and hold the button until the amber light blinks once ortwice indicating current vehicle (one blink = car 1, two blinks =car 2).2. To change from one car to the other press the button again.3. When using the remote to control the system, the amber light willflash in a sequence of 1 or 2 flashes indicating the current vehicleselected.© 2008 Directed Electronics. All rights reserved.13
Page 4: 2-way remote ......................
Page 7: Warning! Safety firstThe following
Page 11: ed if your warranty registration is
Page 15 and 16: LC 1-way companion102354689Note: Se
Page 17 and 18: Using the systemPlease note the scr
Page 19 and 20: minutes and 1 minute of runtime rem
Page 21 and 22: Turn the ignition key on and then o
Page 23 and 24: Additional arming features Arm Feat
Page 25 and 26: sponse will reset. System overrideT
Page 27 and 28: will beep once.Silent Mode 2 - Turn
Page 29 and 30: unning. If the vehicle shuts down w
Page 31 and 32: still enabled).You can still remote
Page 33 and 34: will shut down when locking).3. Pre
Page 35 and 36: Remote control feature programmingT
Page 37 and 38: Feature Opt 1 Opt 2 Opt 3 Opt 4 Opt
Page 39 and 40: down the menu. . The hour
Page 41 and 42: DiagnosticsThe microprocessor at th
Page 43 and 44: Disarm 3 disarmed with Low battery
Page 45 and 46: defeat toggle switch is off.Keep a
Page 47 and 48: Programming optionsYour system has
Page 49 and 50: Security & convenience expansions
Page 51 and 52: Glossary of terms2-Way Remote: A ha
Page 54 and 55: 17 27 Car Door18 Pager Tone On 28
Page 56 and 57: Location of Shutdown Toggle Switch_
Page 58: SHALL BE STRICTLY LIMITED TO THE AU

Owner's Guide - DirectedDealers.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?