Owner's Guide - DirectedDealers.com

minutes and 1 minute of runtime remaining, it sends the 2-way remotecontrol a paging signal.Points to remember:If the hood is open or if the brake pedal is pressed, the vehicle will notremote start. The remote start shuts down:When the brake pedal is pressed.The hood is opened.When the remote start command is sent again from a remotecontrol. To drive your vehicle after it has been remote started:1. 2. Insert the ignition key and turn it to the ON position.3. Now, step on the brake.The remote control will play the remote start shutdown tone. You havenow taken direct control from the remote start system.Valet Take-Over the key has been removed from the ignition. This feature is useful for of time, but would like to leave the motor running and the climatecontrols on. 1 timeand the parking lights will flash after a couple of seconds turn off the can lock the system and the car will remain running. If the vehicle shutsdown, then the unit did not enter valet take-over mode.© 2008 Directed Electronics. All rights reserved.19