Owner's Guide - DirectedDealers.com

More documents

Recommendations

Info

For example: If zone 3 was active or triggered, the LED will blink threetimes with a two-second pause. Then it will blink three times again, andrepeat until the ignition is turned on. Nuisance prevention® circuitry prevents annoying repetitive trigger sequences due to faulty door pinswitches or environmental conditions such as thunder, jackhammers,airport noise, etc.For example: If the alarm triggers three times within a 60-minute periodand each time the same sensor or switch triggers the alarm, NPC willinterpret those triggers as false alarms. After the third trigger, NPC ignores,or bypasses, that sensor or switch (along with any other sensorsor switches sharing the same zone) for 60 minutes.If the bypassed sensor tries to trigger the security system while it is beingbypassed, the 60-minute bypass period will start over. This ensures thata sensor that is continually being triggered will remain bypassed.The vehicle doors are protected by NPC differently. If your securitysystem is triggered by an open door for three full cycles, the system willbypass the doors until the trigger ceases. Remote StartThis system can provide you with information to indicate what the problem iswhen using the remote start. When the remote start is activated and fails toengage, count the parking light flashes to determine the problem. The parkinglights will flash between 5 - 8 times to indicate what caused the no start situation. 44 © 2008 Directed Electronics. All rights reserved.
defeat toggle switch is off.Keep a record of the number of flashes, to assist your installer when taking thevehicle in for service.Owner recognitionOwner Recognition lets up to four users of the system have unique settingsthat meet their specific needs. It is almost like having four separatealarms in your vehicle, one for each user. This feature is only availableto authorized dealers using the Bitwriter or Bitwriter 2 program tool.Rapid resume logicThis Directed system will store its current state to non-volatile memory.If power is lost and then reconnected the system will recall the storedstate from memory. for any reason, such as servicing the car, when the battery is recon- © 2008 Directed Electronics. All rights reserved.45
Page 4: 2-way remote ......................
Page 7: Warning! Safety firstThe following
Page 11 and 12: ed if your warranty registration is
Page 13 and 14: Battery Replacement
Page 15 and 16: LC 1-way companion102354689Note: Se
Page 17 and 18: Using the systemPlease note the scr
Page 19 and 20: minutes and 1 minute of runtime rem
Page 21 and 22: Turn the ignition key on and then o
Page 23 and 24: Additional arming features Arm Feat
Page 25 and 26: sponse will reset. System overrideT
Page 27 and 28: will beep once.Silent Mode 2 - Turn
Page 29 and 30: unning. If the vehicle shuts down w
Page 31 and 32: still enabled).You can still remote
Page 33 and 34: will shut down when locking).3. Pre
Page 35 and 36: Remote control feature programmingT
Page 37 and 38: Feature Opt 1 Opt 2 Opt 3 Opt 4 Opt
Page 39 and 40: down the menu. . The hour
Page 41 and 42: DiagnosticsThe microprocessor at th
Page 43: Disarm 3 disarmed with Low battery
Page 47 and 48: Programming optionsYour system has
Page 49 and 50: Security & convenience expansions
Page 51 and 52: Glossary of terms2-Way Remote: A ha
Page 54 and 55: 17 27 Car Door18 Pager Tone On 28
Page 56 and 57: Location of Shutdown Toggle Switch_
Page 58: SHALL BE STRICTLY LIMITED TO THE AU

Owner's Guide - DirectedDealers.com

Create successful ePaper yourself

Delete template?

Save as template?