Owner's Guide - DirectedDealers.com

For example: If zone 3 was active or triggered, the LED will blink threetimes with a two-second pause. Then it will blink three times again, andrepeat until the ignition is turned on. Nuisance prevention® circuitry prevents annoying repetitive trigger sequences due to faulty door pinswitches or environmental conditions such as thunder, jackhammers,airport noise, etc.For example: If the alarm triggers three times within a 60-minute periodand each time the same sensor or switch triggers the alarm, NPC willinterpret those triggers as false alarms. After the third trigger, NPC ignores,or bypasses, that sensor or switch (along with any other sensorsor switches sharing the same zone) for 60 minutes.If the bypassed sensor tries to trigger the security system while it is beingbypassed, the 60-minute bypass period will start over. This ensures thata sensor that is continually being triggered will remain bypassed.The vehicle doors are protected by NPC differently. If your securitysystem is triggered by an open door for three full cycles, the system willbypass the doors until the trigger ceases. Remote StartThis system can provide you with information to indicate what the problem iswhen using the remote start. When the remote start is activated and fails toengage, count the parking light flashes to determine the problem. The parkinglights will flash between 5 - 8 times to indicate what caused the no start situation. 44 © 2008 Directed Electronics. All rights reserved.