Installation Instructions - Vivid Racing

More documents

Recommendations

Info

www.vf-engineering.comPorsche 997 (US MODEL) Stage1 INSTALLATION11. Swing the bumper rebar back into place and tighten the OEM bolts to factory specifications.Relocate the homelink bracket (with box) to the passenger side of water tank, using a pre existinghole in the bumper reinforcement.12. Moving to the underside of the car, Mount the Bosch® electric water pump and bracket suppliedin your kit to the driver side of the rear chassis crossbar located just below the transmission.Mount the pump as shown below; making sure the pump will not interfere with the shift linkage orsuspension components when the car is in use.PAGE 12 of 51P/N: VFM59-01© 2006 VF EngineeringAll rights reservedRev 1.11.21.06
www.vf-engineering.comPorsche 997 (US MODEL) Stage1 INSTALLATION13. Lay out the water lines supplied in the kit (as shown below) to familiarize yourself with theirrouting.14. Route the driver’s side lateral hose from the water pump’s output (large connection), through thedriveshaft tunnel up towards the front of the vehicle. Make sure the hose will not interfere with anymoving parts. Connect the hose to the water pump.PAGE 13 of 51P/N: VFM59-01© 2006 VF EngineeringAll rights reservedRev 1.11.21.06
Page 1 and 2: www.vf-engineering.comPorsche 997 (
Page 11: www.vf-engineering.comPorsche 997 (
Page 51: www.vf-engineering.comPorsche 997 (

Installation Instructions - Vivid Racing

Create successful ePaper yourself

Delete template?

Save as template?