Installation Instructions - Vivid Racing

More documents

Recommendations

Info

www.vf-engineering.comPorsche 997 (US MODEL) Stage1 INSTALLATION60. Remove the MAF sensor from your OEM Porsche airbox and install it in the new MAF housingsupplied with your kit. CARE SHOULD BE TAKEN WHEN HANDLING THE MAF. Install the K&Nfilter supplied in your kit to the MAF housing.61. Install the 90 degree air intake pipe included in the kit to the other end of the MAF housing, usingthe supplied clamps. Install theses pieces as a unit into the passenger side of the engine bay asshown below. Connect the MAF to its respective plug.PAGE 42 of 51P/N: VFM59-01© 2006 VF EngineeringAll rights reservedRev 1.11.21.06
www.vf-engineering.comPorsche 997 (US MODEL) Stage1 INSTALLATION62. Install the supercharger intake pipe along the bottom of the engine bay, connecting it to thesupercharger and the intake assembly in the corner of the engine bay.63. Attach the silicone charge cooler outlet pipe to the charger cooler and install the assembly intothe vehicle as shown below.**TIP: The charge cooler outlet pipe may need to be trimmed to allow for adequateclearance of the charge cooler when hood is shut.PAGE 43 of 51P/N: VFM59-01© 2006 VF EngineeringAll rights reservedRev 1.11.21.06
Page 1 and 2: www.vf-engineering.comPorsche 997 (
Page 41: www.vf-engineering.comPorsche 997 (
Page 51: www.vf-engineering.comPorsche 997 (

Installation Instructions - Vivid Racing

Create successful ePaper yourself

Delete template?

Save as template?