Installation Instructions - Vivid Racing

www.vf-engineering.comPorsche 997 (US MODEL) Stage1 INSTALLATION68. Fill the supercharger cooling system with a 50/50 mix of distilled water and phosphate freecoolant via the purge tank. Make sure any air has been evacuated from the system when you arefinished filling to ensure an accurate water level. Check for leaks.69. While the bumper is still off of the vehicle, replace the factory installed center grill in the lowerportion of the bumper with the OEM replacement pieces supplied in the kit.70. Remove the tin covering the underside of the engine cover (hood) and outline (as shown below)the area that will need to be trimmed for clearance of the supercharger. Trim with care while thecover is off of the vehicle, and treat any exposed metal left after cutting with paint or primer toprevent rust. Reinstall the tin covering when finished.PAGE 46 of 51P/N: VFM59-01© 2006 VF EngineeringAll rights reservedRev 1.11.21.06