Installation Instructions - Vivid Racing

More documents

Recommendations

Info

www.vf-engineering.comPorsche 997 (US MODEL) Stage1 INSTALLATION30. Replace the fuel injectors with the new injectors supplied in the kit. Reinstall the retaining clip inthe same orientation from which they were removed.31. Reinstall the fuel rail and fuel rail bolts, making sure that all three injectors seat properly in thehead.32. Reconnect the fuel injector electrical connections, making sure they are connected to the samecylinder from which they were removed. Be sure an audible ‘click’ is heard when connecting thefuel injectors to ensure a proper connection has been made.33. Reconnect the intake air temperature sensor and remount the plastic engine wire harness casingto the fuel rail.34. Moving to the driver side, disconnect the cam position sensor, vacuum solenoid connection,plastic engine wire harness casing from fuel rail, and vacuum line clip to gain access to the fuelrail bolts. Remove the fuel rail bolts and pull the fuel rail up slightly to gain access to the fuelinjector connections. Remove the fuel injector connections, noting which cylinder each connectionis associated with.PAGE 28 of 51P/N: VFM59-01© 2006 VF EngineeringAll rights reservedRev 1.11.21.06
www.vf-engineering.comPorsche 997 (US MODEL) Stage1 INSTALLATION35. Repeat steps 28-31, this time, on the driver side.36. Reconnect the cam position sensor, vacuum connections and clips, and remount the plastic fuelinjector wiring casing.37. Remove the alternator (with pulley), throttle body, and oil fill tube to gain access to the rearcrankcase ventilation tube fitting.PAGE 29 of 51P/N: VFM59-01© 2006 VF EngineeringAll rights reservedRev 1.11.21.06
Page 1 and 2: www.vf-engineering.comPorsche 997 (
Page 27: www.vf-engineering.comPorsche 997 (
Page 51: www.vf-engineering.comPorsche 997 (

Installation Instructions - Vivid Racing

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?