Installation Instructions - Vivid Racing

More documents

Recommendations

Info

www.vf-engineering.comPorsche 997 (US MODEL) Stage1 INSTALLATION18. Route the front driver side water hose supplied in your kit, starting from the front of the driveshafttunnel where the lateral hose ends, along the side of the gas tank, to the front of the vehicle andattach to bottom fitting of the VF-Engineering water tank you installed earlier. Make sure hosedoes not interfere with any moving parts, especially front suspension components. Replaceradiator shroud. Attach front hose to lateral hose.PAGE 18 of 51P/N: VFM59-01© 2006 VF EngineeringAll rights reservedRev 1.11.21.06
www.vf-engineering.comPorsche 997 (US MODEL) Stage1 INSTALLATION19. Install the water pump relay included with the kit on the small bracket located on the passengerside of the battery.20. Run the wiring coming from the water pump along the driver’s underside of the vehicle, and intothe battery compartment via the rubber grommet located behind the front driver side wheel welllining. Wire tie as necessary.Make the connections at the relay as follows:• ‘30’ – Water pump positive• ‘85’ – Positive source when key is in ‘ON’ position• ‘87’ – Positive source from battery• ‘86’ – GroundPAGE 19 of 51P/N: VFM59-01© 2006 VF EngineeringAll rights reservedRev 1.11.21.06
Page 1 and 2: www.vf-engineering.comPorsche 997 (
Page 17: www.vf-engineering.comPorsche 997 (
Page 51: www.vf-engineering.comPorsche 997 (

Installation Instructions - Vivid Racing

Create successful ePaper yourself

Delete template?

Save as template?