You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Parameterization2.9.3 Equidistant DP cycle T DPDuring the calculation of the cyclic component of the DP communication, the valuefor the equidistant DP cycle is automatically changed to the minimum required timeby the DP master. This change must be undone by re-entering the intended valuefor the equidistant DP cycle.Dialog: ContinuationOKOKDialog box: “Options”Equidistant DP cycle: Equidistance timeOKOptions“Equidistance” Network nodesLinesActivate equidistant bus cycle / Recalculate equidistant timeNumber of PGs/OPs/TDs on the PROFIBUS00Graduation:Equidistant DP cycle:2.000ms0.001 msDetails ...(minimum 0.427 ms)Synchronization of the slavesTimes Ti and To same for all slaves(If not: Set in Properties - Slaves)Time Ti (Input process values)msTime To (Output process values)msOKCancelHelpFig. 2-7Dialog: Options Siemens AG, <strong>2003</strong>. All rights reserved<strong>ADI4</strong> – Analog Drive Interface for 4 Axes, <strong>02</strong>.<strong>2003</strong> Edition2-53
Change language