A-Teachers-Guide-to-the-Intel-Galileo-Final

More documents

Recommendations

Info

23 | Beginning with Arduino4. From the ‘Utilities’ menu, add a ‘Delay Milliseconds’ block underneath the two SetDigital Pin blocks. Set both delays to 1000 milliseconds. These delays will create theblinking light effect.5. Click on ‘Upload’, and the text-based code will appear in the sketch window of theArduino IDE. Click on ‘Upload’ within the Arduino IDE to send this code to the Galileo.
A TEACHER’S GUIDE TO THE INTEL® GALILEO | 24Button with Ardublock1. From the ‘Control’ menu, place a ‘Loop’ block in your work area.2. Then connect an ‘If/Else’ block to the loop block.
Page 8: 3 | IntroductionHow to use this gui
Page 14 and 15: 9 | Pedagogical ApproachesAs a proc
Page 16 and 17: 11 | Setting Up Your Intel® Galile
Page 24 and 25: 19 | Beginning with ArduinoCoding I
Page 26 and 27: 21 | Beginning with ArduinoIn this
Page 30 and 31: 25 | Beginning with Arduino3. From
Page 33 and 34: A TEACHER’S GUIDE TO THE INTEL®
Page 79 and 80:
A TEACHER’S GUIDE TO THE INTEL®
show all

A-Teachers-Guide-to-the-Intel-Galileo-Final

Create successful ePaper yourself

Delete template?

Save as template?