Isadora Manual v1.3 - TroikaTronix

At the top you will see the Set Default Output Device… option. Select the
device you would like to use for multi-channel output.
If your device is not listed in the pop-up, quit Isadora and make sure that your
drivers are properly installed, and repeat the above process.
If you only need to route the sound of movies played by the Movie Player, you
can skip this step. Otherwise, if you are using the Sound Player actor to play
sound and want to route their output to various channels on the external
device, you should set up the routing for Isadora’s sixteen sound channels.
These channels correspond to the sixteen channels available in the play
channel property of the Sound Player actor.
When you change the settings under the Sound Output Routing portion of
this dialog, you are specifying the pair of outputs to which a particular sound
channel should be sent. For instance, if you set Channel 1 to Ext. 1-2 and
Channel 2 to Ext 3-4, then sounds played on Isadora’s sound channel 1 would
appear on channels 1 and 2 of your external device, while sounds played on
channel 2 would appear at channels 3 and 4 of your device. Note that you
cannot route Isadora’s sound channels to only one channel of your output
device – you must choose a pair. (You can, however, use the Pan property to
send your sound only to one channel or the other.)
• If you would like the current Sound Output settings to be the default when you
next create a new document, click the “Use As Default” button. This stores
the current routings in your preferences so that new documents will use these
settings.
• Click OK to confirm your settings and dismiss the dialog.
Isadora Manual
152