Section 2

Bose ® Modeler ® Software User GuideTip:Zoom in on the model to make drawing surfaces easier. Select theZoom tool and click on an area of your model to zoom in on it. Tozoom out, hold down Ctrl and then click. You can also use thekeyboard shortcuts [ and ]. If you have a scroll wheel mouse, youcan zoom in or out by holding the Ctrl key and scrolling up anddown.Figure 6.22 - Zoom tool2. Move the cross-hair cursor and click at the following locations tocreate your shape. (You will be starting at the upper right cornerof the highlighted shape in Figure 6.21) Note that at each click,the coordinates at the mouse pointer reset to x: 0.0 y: 0.0 z:0.0.• Click at x: - 12 y: 7.0 z: 0.0• Click at x: - 3.0 y: 0.0 z: 0.0• Click at x: 0.0 y: - 3.5 z: 0.0• Click at x: - 3.0 y: 0.0 z: 0.0• Click at x: 0.0 y: - 3.5 z: 0.0• Click at x: 6.0 y: 0.0 z: 0.0• Click at x: 0.0 y: 7.0 z: 0.0 (which is the red dotindicating the starting point)Tip:If you make a mistake while creating a shape, press Esc to cancelwhat you have done.Chapter 6: Modeling Workshop 115