FVA/A1 STERILIZERS

4. TRANSPORT, HANDLING AND STORAGE
FVA/A1 - OPERATION AND
MAINTENANCE MANUAL
4.1. TRANSPORT
If the sterilizer is to be transported outside the destination areas, it is recommended to follow the procedures for the loading and
unloading operations described in the technical manual of the machine.
! WARNING!
Improper use of the lifting or anchoring devices of the machine can cause severe damage to the machine and to its
operators.
4.2. HANDLING
All FVA/A1 models are provided with a suitable stand on a set of four wheels, which ensures easy handling both during installation
and during maintenance or emergency.
Final placement of the machine at the installation site is generally performed by two operators.
To ensure correct and safe handling of the machine, it is recommended to perform the following steps:
1. remove the enclosure that protects the machine, separating it from the platform that constitutes the base of the package;
2. transport the machine, keeping it fixed to the base of the package, to the installation site, and then deposit it on the floor of the
room;
3. remove the locking devices;
4. lift the machine, freeing it from the pallet.
! WARNING!
If the handling of the machine requires lifting, check that the cables and the lifting means are suitable for the
required capacities and have the approvals required by the relevant local laws.
4.3. STORAGE
The machine can be stored in a closed dry room with a temperature comprised between 4°C and 50°C and a relative humidity of no
more than 80%.
If rooms suitable to ensure these environmental conditions for machine storage are not available, it is advisable to ask FEDEGARI to
supply the machine with a heat-sealed enclosure made of multi-ply barrier material in a sea case.
! WARNING!!
Sunlight can cause severe damage to the plastic and rubber parts. Direct exposure to the sun for prolonged periods
must be avoided.
; CAUTION
Storage periods of less than two months are recommended. If longer periods are necessary, the gaskets should be
treated with silicone oil in order to prevent early deterioration or unwanted sticking. After particularly long storage
periods, it may be necessary to replace gaskets and seals before returning the machine to production status.
ID no. 85693 Rev. 2 16 / 31 July 2005