ORION Commercial 'LULA' Elevator - Advanced Lift Solutions

Recommendations

Info

o r i o n co m m e r c i a l ‘l u l a’ e l e vat o r 12 of 145 THE fOLLOwING SAfETY INSTRUCTIONS MUST BE ADHERED 2.0 INSTALLATION SAfETY TIPS The following safety installation tips must always be followed. Please read and understand this entire manual before installing the unit and carefully follow all procedures. 1) Proper, safety-approved protection for your head, eyes, hands, and feet should be worn during all phases of the installation. 2) Use extreme caution while raising the elevator components into position to avoid personal injury or damage to the equipment. 3) Use extreme care when operating units without panels in place to avoid personal injury from moving parts. 4) Power should be removed from the drive unit and operating systems when any electrical work or adjustments are being done. 5) To avoid possible electrical shock, you should not work on a wet floor or enter an elevator or elevator pit when it contains water. 6) Use only recommended anchor fasteners. 7) Never work alone and always be aware of fellow workers and their safety. 8) DO NOT wear loose-fitting clothing during installation. Shirt cuffs should be buttoned to avoid being caught in moving machinery. 9) Ensure that all electrical and mechanical equipment is properly enclosed. 10) Never place yourself in a position where you may be harmed (i.e., between shear points, under heavy objects, in the path of moving parts, etc.). 11) Never stand directly under the cab or inside the hoistway during testing or when power is being supplied to the cab itself. 12) Hoistway doors should be locked or nailed shut any time the area is left unattended. 13) Always remember and practice, SAfETY fIRST. TO AT ALL TIMES. PRACTICE SAfETY fIRST. Orion Installation Guide PN 000581 (18-m06-2010)
2.1 PRELIMINARY CHECKS Pre-Delivery Check Carefully check all measurements of the lift hoistway enclosure and compare to the site Installation Drawings. Main items to be checked are: Items to be checked against site Installation Drawings Total travel from the bottom finished floor level to the top finished floor level. Clearance overhead. Top finished floor sill to top of the hoistway. Measure width and depth of hoistway. Check to ensure hoistway is “square”. Pit depth (check for equal depth and level). Size and location of the landing door or doors rough openings. Location of the machine (pump) room. Location of the electrical power disconnect switches. Correct voltage, three phase or single and the proper size of wire (assure compliance with local codes). Ensure the jack unit can be placed in the hoistway (clear access to hoistway/runway). Review “Provisions by Others” with site supervisor. Check that all walls/barriers surrounding hoistway area are smooth, solid, vertical and perpendicular to the floor and walls are square to each other. NOTE: It is important walls are perfectly level due to tight running clearances. Check oil and electrical line “sleeves” from machine room to hoistway. Confirm rail support wall is properly installed with adequate backing as per appropriate drawing. Pre-Installation Check Orion Installation Guide PN 000581 (18-m06-2010) note Checklist We strongly recommend that you conduct a before installation check when you receive shipment to verify contents for damaged or missing parts. Uncrate all boxes and spread out the parts. Carefully check for damages that you must report to your carrier immediately and check for missing materials against our shipping list. NO CLAIMS FOR SHORTAGE WILL BE ALLOWED UNLESS REPORTED WITHIN 24 HOURS OF RECEIPT OF SHIPMENT. � � � � � � � � � � � � � 13 of 145 o r i o n co m m e r c i a l ‘l u l a’ e l e vato r
Page 1: ORION Commercial ‘LULA’ Elevato
Page 4 and 5: 1 8 15 22 31 Install Rails and Rail
Page 6 and 7: o r i o n co m m e r c i a l ‘l u
Page 66 and 67:
o r i o n co m m e r c i a l ‘l u
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 151:
APPENDIx A ELECTRICAL SCHEMATICS PN
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240:
show all

ORION Commercial 'LULA' Elevator - Advanced Lift Solutions

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?