- Page 1: ORION Commercial ‘LULA’ Elevato
- Page 5 and 6: IMPORTANT This Orion Commercial “
- Page 7 and 8: 5.7 PLATfORM INSTALLATION 56 5.8 SE
- Page 9 and 10: APPENDIx A ELECTRICAL SCHEMATICS (s
- Page 11 and 12: 1.1 INTRODUCTION This manual contai
- Page 13 and 14: 1.3 TOOLS AND MATERIALS REQUIRED o
- Page 15 and 16: TERMINOLOGY DESCRIPTION Machine Roo
- Page 17 and 18: 2.1 PRELIMINARY CHECKS Pre-Delivery
- Page 19 and 20: Orion Installation Guide PN 000581
- Page 21 and 22: Orion Installation Guide PN 000581
- Page 23 and 24: Installation Procedure To install t
- Page 25 and 26: 8) Scribe a centre line on the back
- Page 27 and 28: 14) Now using a tape measure, check
- Page 29 and 30: Orion Installation Guide PN 000581
- Page 31 and 32: 3.2.2 Cylinder Barrel Assembly 1) E
- Page 33 and 34: Orion Installation Guide PN 000581
- Page 35 and 36: IMPORTANT The Jack Bracket must be
- Page 37 and 38: 3.4 SHEAVE/GUIDE YOKE INSTALLATION
- Page 39 and 40: 3.5 LIfT CHANNEL UPRIGHTS (STILES)
- Page 41 and 42: 7) The cables are normally shipped
- Page 43 and 44: 3.5.1 Stile Retainer Bracket Instal
- Page 45 and 46: Orion Installation Guide PN 000581
- Page 47 and 48: figure 45 Rail Buffer (L/H Shown) f
- Page 49 and 50: 5.0 HYDRAULIC INSTALLATION When the
- Page 51 and 52: 5.1 OVERSPEED VALVE INSTALLATION AN
- Page 53 and 54:
L A B A Main Shut OFF Valve Handle
- Page 55 and 56:
The hydraulic system is now ready f
- Page 57 and 58:
5.5 CABLE INSTALLATION Orion Instal
- Page 59 and 60:
5.6 PIT PROP General The purpose of
- Page 61 and 62:
figure 60 Platform Installation Ori
- Page 63 and 64:
7) Remember to check the Plank Swit
- Page 65 and 66:
9) Feed the governor cable through
- Page 67 and 68:
5.11 TAPE READER 1) Bolt the tape b
- Page 69 and 70:
Slowdown Up Level, Down Level & Doo
- Page 71 and 72:
Refer to the table below to determi
- Page 73 and 74:
Orion Installation Guide PN 000581
- Page 75 and 76:
Orion Installation Guide PN 000581
- Page 77 and 78:
6.1 CAR OPERATING PANEL (COP) INSTA
- Page 79 and 80:
Orion Installation Guide PN 000581
- Page 81 and 82:
4) Mount the upper gate track, alon
- Page 83 and 84:
Header Gate Leading Edge Orion Inst
- Page 85 and 86:
6.5 PORTA - GATE OPERATOR INSTALLAT
- Page 87 and 88:
ntroller to interface board. Reinst
- Page 89 and 90:
Orion Installation Guide PN 000581
- Page 91 and 92:
6.7 PORTA - GATE TROUBLESHOOTING Pr
- Page 93 and 94:
6.9 CTIS INSTALLATION Select the ap
- Page 95 and 96:
Option B (If Hoistway Dimensions Pe
- Page 97 and 98:
7.1 HOISTwAY JUNCTION BOx INSTALLAT
- Page 99 and 100:
7.4 CONTROLLER LAYOUT AND wIRING Or
- Page 101 and 102:
7.4.2 Controller Grounding Groundin
- Page 103 and 104:
Orion Installation Guide PN 000581
- Page 105 and 106:
7.6 TERMINATION Of wIRING AT CONTRO
- Page 107 and 108:
7.8 POwER UP AND TEST THE ELEVATOR
- Page 109 and 110:
1) Begin at the bottom floor and mo
- Page 111 and 112:
c) The operator may have to be remo
- Page 113 and 114:
8.1.3 Potentiometer (POT) Adjustmen
- Page 115 and 116:
8.1.4 Setting the Cams There are tw
- Page 117 and 118:
5) If the latch bolt operation appe
- Page 119 and 120:
10.0 ADJUSTING AND SETTING THE EPV
- Page 121 and 122:
A Main Shut OFF Valve Handle B Main
- Page 123 and 124:
Orion Installation Guide PN 000581
- Page 125 and 126:
3) Raise the car with the Temporary
- Page 127 and 128:
1) The EPV solenoid is fully closed
- Page 129 and 130:
10.7 SPEED SETTING DESCRIPTIONS The
- Page 131 and 132:
If the processor detects no input f
- Page 133 and 134:
If the setting is too long, the DEC
- Page 135 and 136:
12.0 TESTING OPERATION The followin
- Page 137 and 138:
15.0 TEST REDUNDANCY CIRCUIT (TSSA,
- Page 139 and 140:
f) Critical Component: SB1 Relay Re
- Page 141 and 142:
181.50 Single Ground Tests Ground a
- Page 143 and 144:
EI.16 Negative Pressure Switch: Pla
- Page 145 and 146:
d) Critical Component: IAS Relay Te
- Page 147 and 148:
181.20 Solid State Device Test Not
- Page 149:
(189.00) Additional Tests a) Top of
- Page 153 and 154:
Orion Installation Guide PN 000581
- Page 155 and 156:
KIT # DESCRIPTION PARTS INCLUDED IN
- Page 157 and 158:
000581 INSTALLATION MANUAL 000586 O
- Page 159 and 160:
KIT# DESCRIPTION 209095 DECAL LOW O
- Page 161 and 162:
250899 HALL WIRING KIT, 4 FLOOR ORI
- Page 163 and 164:
Orion Installation Guide PN 000581
- Page 165 and 166:
2.0 CONTROLLER INSTALLATION AND wIR
- Page 167 and 168:
other lead to each terminal to be t
- Page 169 and 170:
3) Using a Volt/Ohm meter check the
- Page 171 and 172:
4.0 fINAL ADJUSTMENTS When the cont
- Page 173 and 174:
4.7 faults Most faults can be reset
- Page 175 and 176:
5.0 MICRO-PROCESSOR HARDwARE DESCRI
- Page 177 and 178:
Error Code Description Caused by Re
- Page 179 and 180:
Monitoring Input/Output Status The
- Page 181 and 182:
8. Bit number 21 must be properly s
- Page 183 and 184:
Dupline Inputs The following inputs
- Page 185 and 186:
Dupline Inputs cont. 5HR 5th Ldg Re
- Page 187 and 188:
Dupline Outputs cont. NAME Descript
- Page 189 and 190:
8.0 PARTS LIST ITEM DESCRIPTION MAN
- Page 191 and 192:
9.3 Monitoring Display format Examp
- Page 193 and 194:
List of BIT features The following
- Page 195 and 196:
07 Enable Rear Opening at 2nd Landi
- Page 197 and 198:
28 Stop at Main Ldg - With this fea
- Page 199 and 200:
Listing of INT Settings The followi
- Page 201 and 202:
06 Door Time, Short - This is the t
- Page 203 and 204:
33 Arrival Gong and Passing Gong Ti
- Page 205 and 206:
9.7 floor Position Codes - Grey Cod
- Page 207 and 208:
16 32 64 128 256 Orion Installation
- Page 209 and 210:
The fourth digit shows the status o
- Page 211 and 212:
D Energized when running down. FS E
- Page 213 and 214:
10.7 DAT Troubleshooting Techniques
- Page 215 and 216:
06-01-04 (INT29=17, TSSA=17001) 1)
- Page 217 and 218:
10-02-02 (INT29=8) 1) Change Consta
- Page 219 and 220:
13.0 CONTROLLER MAINTENANCE 13.1 CP
- Page 221 and 222:
©Savaria Concord Lifts Inc. PN 000
- Page 223 and 224:
Orion Installation Guide PN 000581
- Page 225 and 226:
Orion Installation Guide PN 000581
- Page 227 and 228:
2 Unless otherwise specified, Savar
- Page 229 and 230:
4 Board layout Figure 1 describes t
- Page 231 and 232:
6 Step 2 Adding a secondary telepho
- Page 233 and 234:
8 Step 6 Enabling/disabling outgoin
- Page 235 and 236:
Orion Installation Guide PN 000581
- Page 237 and 238:
Orion Installation Guide PN 000581
- Page 239 and 240:
figure 2 Hall Station Dupline Wirin
- Page 242:
107 Alfred Kuehne Blvd. Brampton, O