ORION Commercial 'LULA' Elevator - Advanced Lift Solutions

Recommendations

Info

o r i o n co m m e r c i a l ‘l u l a’ e l e vat o r 3) Mark the centerline location on the wall and then, drop a plumb from this point. Be as accurate as possible here and verify that your measurements are within +/- 1/32”. “Snap” a chalked plumb line to mark the centerline from the top of the hoistway to the bottom, refer to Figure 8. 4) Prepare a 4 foot (1219 mm) carpenter’s level as a “template” to mark the location of the rail bracket holes. Use a small tip permanent ink marker for this purpose. On the carpenter’s level mark the centerline and the position of each bracket hole to be drilled in the wall. Refer to Figure 9. 20 of 145 figure 9 Carpenter Level Template 5) Starting at the top of the hoistway, use the prepared 4 foot carpenter’s level to mark the position of the rail bracket mounting holes. a) Place the marked center point of the level even with the marked center of the rail bracket/cylinder bracket on the wall. b) Ensure that the level is “level” and then, mark the location of each rail bracket hole. c) Descend to each level and repeat this procedure at each rail bracket location. d) The exact number of brackets and their locations are shown on the Installation Drawings. 6) Drill holes for each rail bracket. (Wall fasteners may be thru bolts, concrete anchors or lag bolts (for wood walls minimum ½” bolt). Check your Installation Drawings. 7) Completely remove the protective coating from the rail sections and the splice plates. Once cleaned check the rails for burrs and nicks and file down. figure 8 Rail Bracket Centerline figure 10 Drill Holes Orion Installation Guide PN 000581 (18-m06-2010)
8) Scribe a centre line on the back of each rail using a T-square and scribe as shown in Figure 11. This line will be used to align the rail with the leaf brackets using the diamond cut-out on the leaf bracket. 9) (OPTION) At this point preassemble the rail brackets and leaf brackets OR complete this step after the rail brackets are installed (step 11) using the hardware provided. Assemble figure 11 the adjustable leaf brackets making sure that the brackets are pushed back fully as shown in Figure 12 and 13. DO NOT install the rail bracket clips as they will interfere with the use of the rail alignment jig. 10) Refer to the installation drawing to install the splice plates to the top of each rail section using 4 of the splice plate bolts, flats, locks and nuts provided. Bolts need to be snug only as they will be tightened up in the hoistway. CAUTION: Remember that you will be installing one rail “male” side up and the other “female” side up. See step 19. Orion Installation Guide PN 000581 (18-m06-2010) Adjust Leaf Brackets as shown figure 12 Rail Bracket Installed Rail wall Side figure 13 Rail Bracket and Leaf Bracket Assembled 21 of 145 o r i o n co m m e r c i a l ‘l u l a’ e l e vato r
Page 1: ORION Commercial ‘LULA’ Elevato
Page 4 and 5: 1 8 15 22 31 Install Rails and Rail
Page 6 and 7: o r i o n co m m e r c i a l ‘l u
Page 74 and 75:
o r i o n co m m e r c i a l ‘l u
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 151:
APPENDIx A ELECTRICAL SCHEMATICS PN
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240:
show all

ORION Commercial 'LULA' Elevator - Advanced Lift Solutions

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?