ORION Commercial 'LULA' Elevator - Advanced Lift Solutions

Recommendations

Info

o r i o n co m m e r c i a l ‘l u l a’ e l e vat o r 4) Position the yoke assembly on top of the Jack Platen Plate making sure the guide shoes engage smoothly onto the rails and the two bolt holes on the Jack Platen Plate line up. Insert the bolts into the two bolt holes and install the nuts but do not tighten. 5) “Line up” the yoke with the centerline of the rails before tightening the shoe bolts and ensure that the clearance between the shoe and the rail is approximately 1 /16” (2 mm) on each side. Adjustment is provided on each end of the channel. 6) Tighten the Jack Platen Plate bolts to the Yoke. The inside edge of the sheave should now be “lined up” with the centreline of the rails and the center of the sheave should be “in line” with the centerline of the jack unit. THIS IS IMPORTANT! 7) Tighten the shoe bolts to the yoke. 8) Ensuring the guide shoes are approximately 1 /16” from the rail, tighten the eight (8) bolts on the yoke assembly. 9) Loosen the four (4) bolts holding each of the two small channels inside the yoke (located on either side of the sheave). These channels are designed to prevent the cables from leaving (jumping) the sheave, in the event of the cables slackening. Once the cables are in place, these small channels will be re-positioned as close to the sheave as possible, usually within ⅛” (3 mm), and then tightened. 34 of 145 NOTE The D.B.G. is 30” and; therefore, the distance inside to inside of the guide shoes should be 29 ⅞”. It can be a little greater, but it should NEVER BE LESS. figure 30 Jack Platen Plate without Car Top Prop figure 31 Jack Platen Plate with Car Top Prop Orion Installation Guide PN 000581 (18-m06-2010)
3.5 LIfT CHANNEL UPRIGHTS (STILES) AND SLING The safety blocks are shipped in a small cardboard box. The blocks are covered with a protective coating that must be removed. The best way to remove the coating is by soaking them in a bucket of paint thinner. Once they are cleaned up, they are ready to install. Orion Installation Guide PN 000581 (18-m06-2010) NOTE There is a left and a right safety block. Ensure they are placed properly so that as the sling lowers, the knurled wheel is driven up into the wedge. To install the sling assembly proceed as follows: 1) Bolt the safety blocks securely to the stiles with lock washers. Ensure the proper length bolts are used so that they are threaded at least ½” (13 mm) into the safety block. See Figure 32 and Figure 33. 2) Loosely bolt the four (4) guide shoes on the “inside” of the lift channel uprights (stiles) and position the lift frame (sling) between the guide rails (Figure 34). 3) Position the uprights on the rails one side at a time, securing each side to the rails. figure 32 Safety Block (R/H)Shown) figure 33 Adjusting Safety Block 35 of 145 o r i o n co m m e r c i a l ‘l u l a’ e l e vato r
Page 1: ORION Commercial ‘LULA’ Elevato
Page 4 and 5: 1 8 15 22 31 Install Rails and Rail
Page 6 and 7: o r i o n co m m e r c i a l ‘l u
Page 88 and 89:
o r i o n co m m e r c i a l ‘l u
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 151:
APPENDIx A ELECTRICAL SCHEMATICS PN
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240:
show all

ORION Commercial 'LULA' Elevator - Advanced Lift Solutions

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?