Manual iE5

Chapter 6. Basic Operation
• If setting frq with volume resistance on the loader and commanding operation with RUN key on the loader
No. Indication Operation & description
1
-. Target frequency, the first code of Drive Group when turning it on.
-. Press UP() key three times.
2
-. Moved to a code to change a frequency setting mode
-. Press FUNC key.
3
-. The current frequency setting mode is set to 1(terminal)
-. Press DOWN () key.
4
-. Operation command mode may be changed to 0(RUN key of the loader).
-. Press FUNC key twice.
5
-. It displays drv and operation command mode is changed to RUN key.
-. Press UP() key once.
6
-. Moved to frequency setting mode(Frq) code.
-. Press FUNC key.
7
-. Frequency setting mode is changed to 0(keypad of the loader).
-. Press UP() key two times.
8
-. Frequency setting mode may be changed to 3(loader’s volume resistance).
-. Press FUNC key twice.
9
-. It displays Frq and frequency setting mode is changed to loader volume.
-. Turn the loader volume to set to 10.00 in either Max or Min direction.
10
-. Press RUN key. FWD(forward run) lamp of the inverter display blinks and
accelerating frequency is displayed on the LED.
-. When run frequency 10Hz is reached, it is displayed as shown left.
-. Press STOP key.
11
-. FWD(forward run) lamp of the inverter display blinks and decelerating frequency is
displayed on the LED.
-. When run frequency 10Hz is reached, FWD(forward run) lamp is out and target
frequency(10.00) is displayed on the LED.
Wiring diagram
Operating pattern
220 Vac
L1 (R)
L2 (S)
U
V
M
10 Hz
(T)
P
P1
W
SHFT
RUN
Frequency
RUN
N
G
FUNC
STOP
STOP/RST
6-3