Manual iE5

Chapter 7. Function List
• PG Group
Display Name
Min/Max
range
P13 DC brake start 0 ~ 200
voltage [%]
P14 DC brake start 0 ~ 60
time
[sec]
P15 Jog frequency 0 ~ 200
[Hz]
P16 Max
40 ~ 200
frequency [Hz]
Description
It sets the amount of DC voltage before a motor
starts to run. Motor rated current(P43)
It applies the current to a motor for the set time
before motor accelerates.
It sets the frequency for jog operation. It can not
be set above the max frequency(P16).
This parameter sets the upper limit frequency.
It is frequency reference for Accel./Decel.
Adj.
Factory
during
defaults
run
Page
50 X 10-2
0.0 X
10.00 O 10-3
60.00 X 9-8
Note
If changing the max frequency, all other
frequency parameters but P17(base frequency)
would be changed to the frequency if they are
above the new max. frequency.
P17 Base
frequency
30 ~ 200
[Hz]
P18 Start
0.1 ~ 10
frequency [Hz]
P19 Torque boost 0 ~ 1
selection
P20 Forward
torque boost
P21 Reverse
torque boost
0 ~ 15
[%]
P22 V/F pattern 0 ~ 1
The inverter outputs its rated voltage to the 60.00 X 9-11
motor at this frequency.
The inverter starts to output its voltage at this 0.5 X
frequency.
It is lower frequency limit of frequency(Hz).
0 Manual torque boost
0 X 9-13
1 Auto torque boost
Torque boost amount of motor during forward 5.0 X
run, based on max. output voltage.
Torque boost amount of motor during reverse 5.0 X
run based on max. output voltage.
0 Linear 0 X 9-11
1 Square
9-12
7-4