Manual iE5

Chapter 7. Function List
• PG Group
Display Name
P54 Gain for Motor
rpm display
P55 Filter time
constant for AI
input
P56 Min input for
AI(vol/cur)
P57 Frequency
corresponding min
input for AI
Adj.
Min/Max
Factory
Description
during Page
range
defaults
run
1 ~ 1000
[%]
It can monitoring on the rpm display code of
drive group as converting gear ratio of load
system.
100 O 11-1
0 ~ 9999 Adjusts the responsiveness of analogue 10 O 9-3
input.
0 ~ 100
[%]
Sets the min value of analogue input as the
percentage of the whole input.
0 O
0 ~ 200 Frequency in case analogue input is the min 0.00 O
[Hz] value.
P58 AI max input 0 ~ 100 Sets the max value of analogue input as the 100 O
[%] percentage of the whole input.
P59 Frequency
corresponding to
AI max input
P60 Filter time
constant for
Volume input
P61 Min value for
volume input
P62 Frequency
corresponding to
volume input
P63 Max. value of
volume input
P64 Frequency
corresponding to
volume input
P65 Criteria for Analog
Input Signal loss
0 ~ 200 Frequency in case analogue input is the 60.00 O
[Hz] max. value.
0 ~ 9999 Adjusts the responsiveness of volume input
operation.
10 O 9-2
0 ~ 100 Sets the min rpm of volume input as the 0 O
[%] percentage of the whole input
0 ~ 200 Frequency at minimum current of volume 0.00 O
[Hz] input
0 ~ 100 Sets the max volume input as the 100 O
[%] percentage of the whole input.
0 ~ 200 Frequency at maximum volume input. 60.00 O
[Hz]
0 ~ 2 0: Disabled
0 O 12-4
1: activated below half of set value.
2: activated below set value.
7-10