REGO-FIX Main Catalogue ENGLISH

Successful clamping since 1972
Combine our ER toolholders with our ER collets to ensure maximum
precision and balance to maximize your tool life. All our products bear the
REGO-FIX triangle – our seal for outstanding Swiss quality.
Meet highest requirements defined by Swiss standards Swiss
people are known to be humble and conservative: All our
measuring data are to be considered as maximum values.
Many other manufacturers are showing the common
measured total internal runout (TIR average). With us, you get
maximum guaranteed values – To your advantage most of the
values are even considerably lower.
Runout TIR of ER standard, ER-UP and MR collets
Clamping diameter d [mm]
TIR max. [mm]
DIN 6499
> ≤ L ISO 15488 B rER std. rER-UP rMR
1 1.6 6 0.015 0.01 0.005 0.002
1.6 3 10 0.015 0.01 0.005 0.002
3 6 16 0.015 0.01 0.005 0.002
6 10 25 0.015 0.01 0.005 0.002
10 18 40 0.02 0.01 0.005 0.002
18 26 50 0.02 0.01 0.005 0.002
26 36 60 0.025 0.01 0.005 0.002
L = ≤ 3 x D
L
L = ≤ 3 x D
d
Key advantages
Rely on the original
Wide clamping range
The slot design allows for a wide clamping range
with best runout TIR along the entire clamping range.
Broad range of products
We offer sizes from ER 8 up to ER 50 and diameters
from 0.2 mm up to 36 mm.
Up to 20 % more clamping length
Improve your runout with up to 20 % more clamping
length in smaller diameters.
Matched tooling system for best fit
The compatibility of the entire system results in
maximum precision, balance and tool life.
ER_collets
Schraffurfaktor keiner
Skizzenfaktor 1
Schriftfaktor 0.7
Technical information
271