2024 - WBR - RHL Regulations

11 – 13 OCTOBER 2024
ENVIRONMENTAL AND TECHNICAL CONTROL SYSTEM
ENVRIONMENTAL AND TECHNICAL CONTROL DOCUMENT
An Environmental and Technical Control form will be issued to you at Registration on the Friday of
the event, when you collect all your Competitor Passes.
This document will contain the following information, for our Team to process during the
Environmental and Technical Control process on the Friday of the event.
‣ Race Number
‣ Name
‣ Class
‣ Parc Ferme Place
‣ Frame Number
‣ Transponder Number
This is the information that will be contained within your Competitor Welcome Pack, please ensure
it is correct.
It is the Competitors responsibility to ensure their equipment and machine go through Environmental
and Technical Control on the Friday of the event.
PROCESS
Environmental and Technical Control is split into three sections:
‣ Control Point 1 -
‣ Control Point 2 -
‣ Control Point 3 -
Environmental Mat, Helmet, Boots, Body Armour, Goggles
Transponders – This is for the collection of Hired Transponders only
Machine
To go through these check point areas, you must have your Competitor Pass and your Environmental
and Technical Control Document, which you would have collected at Competitor Registration
You must follow through the Control Points in order ensuring the RHL Team update your
Environmental and Technical Control Document at each Control Point. Failure to do this will result
in you having to go back to Control Point 1 and re-commence the whole process.
If at the point you enter the Parc Ferme it is found your Environmental and Technical Control Card
are not completed, this will be classified as invalid and you will not be allowed to put your machine
in the Parc Ferme, until this is rectified.
CONTROL POINT 1
This is located at the Entrance to the Event Site, near to the Welcome/Competitor Registration
Offices and will be clearly signposted.
You will need to present the following for inspection/verification:
WESTON BEACH RACE REGULATIONS 2024 Page 24 of 45