SAN Boot Implementation and Best Practices Guide ... - IBM Redbooks

2.12.2 Verifying the ESXi pathing
Follow this procedure to verify the ESXi pathing information:
1. After the installation of ESXi 4 update 1, we need to install Virtual Center to verify that the
multipathing is working. In Virtual Center, click the Summary tab, and on the right side of
the panel you will see the datastore, as shown in Figure 2-122.
Figure 2-122 Summary tab in Virtual Center
2. To check the pathing, right-click the datastore1 and then click Properties, as shown in
Figure 2-123.
Figure 2-123 Properties of the datastore
Chapter 2. SAN Boot implementation with IBM System Storage DS5000 101