SIGMA 8000, 8000 Plus and 8002 Plus Infusion Pump Operator's ...

Options 90, 95 &99
37 Rev. J
OPT.
NO.
90
95
99
OPTION NAME INSTRUCTIONS DISPLAY
DELAYED START
(i.e.: “DLAY STRT)
(Not available on all
models)
CLEAR ALL
PROGRAM
MODES
CLEAR ALL 6 hr
MEMORY
If Primary Mode was not selected above, -Enter option number
for the Option Mode desired to run following the delay.
Go through mode set-up.
If an infusion mode is set up prior to entering this option, that
mode will become the delayed mode and you will not be asked
during the Delayed Start setup to select a mode. -Push RUN.
SET / OPT CODE-
OPT 60 / AUTO PROG / PUSH ENTR
(example, Option 60 entered)
DLAY STRT / OPT 60 / AUTO PROG /STEP
1 / PUSH RUN
RATE KVO / DLAY STRT / 1.5 hrs / OPT 60 /
If a KVO delay start selected (pump runs at KVO rate
AUTO PROG
If not………………………………………………... DLAY STRT /1.5 hrs / OPT 60 / AUTO PROG
Note: Pushing STOP at any time during a delayed start or a
KVO alarm delay pauses the timer. To continue the delay,
push RUN.
Stop the pump. IN STOP/PUSH RUN-
Push OPTIONS. SET/OPT CODE-
Select 95. OPT 95/CLR PRGS/PUSH ENTR-
Push ENTER PRGS CLRD/SET RATE
Note:
Use of this option enables the operator to clear all pump memory, except the following items which must be
cleared individually
• Keylock
• Alarm Volume
• Occlusion Pressure Options
• Maximum RATE or VOL. LIMIT Settings
• Biomedical Mode Entries
Programming Modes
Stop the pump. IN STOP/PUSH RUN
Push OPTIONS. SET/OPT/CODE
Select 99. OPT 99/CLR ALL/PUSH ENTR
Push ENTER ALL CLR/SET RATE