ENVI PRO OPERATION MANUAL - Scintrex

Preparing
2. Use either Scintrex cable number 780547 (the shorter one) for the backpack
configurations or cable number 780550 for the staff configuration.
3. Remove the cable hold-down plate by unscrewing the screws at the 2 o’clock and
4 o’clock positions.
4. Connect the black spade-lug on the bare wire of the cable to the terminal at the 11
o’clock position.
5. Connect the red spade-lug on the white wire of the cable to the terminal at the 11
o’clock position.
6. Place the cable in the smaller slot just below the 3 o’clock position.
7. Re-attach the cable hold down plate.
3—3
Total Field Sensor Cabling
Base-station sensor
1. Orient the sensor so that as you look at the bottom of the sensor (the end with the
terminals), the large square plug is at the 9 o’clock position.
2. Use Scintrex cable number 780546.
3. Remove the cable hold-down plate by unscrewing the screws at the 2 o’clock and
4 o’clock positions.
4. Connect the black spade-lug on the black wire of the cable to the terminal at the
11 o’clock position.
5. Connect the red spade-lug on the white wire to the terminal at the 1 o’clock
position.
6. Place the cable in the larger slot just above the 3 o’clock position.
7. Re-attach the cable hold down plate.
Base-Station Sensor Cabling
Gradiometer Sensors - Lower Sensor
1. Orient both the sensors so that as you look at the bottom of the sensors (the end
with the terminals), the large square plug is at the 9 o’clock position.
2. Use Scintrex cable number 788028 - it has four conductors.
3. Select the lower sensor - it has pairs of terminals at the 12 o’clock and 6 o’clock
positions, as well as an attached cable to the terminals at the 6 o’clock position. See
Gradiometer sensor cabling on page 3—4.
P/N 788715 Rev. 0