ENVI PRO OPERATION MANUAL - Scintrex
ENVI PRO OPERATION MANUAL - Scintrex
ENVI PRO OPERATION MANUAL - Scintrex
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Console<br />
Console Description<br />
# Item Description<br />
1 Keypad The fully sealed Keypad has 19 keys and a sound port.<br />
2<br />
3<br />
4—2<br />
Liquid Crystal<br />
Display (LCD)<br />
Carrying Strap<br />
Attachment<br />
4 Sensor Connector<br />
5.<br />
6<br />
Data Output<br />
Connector<br />
Charger/External<br />
Power Connector<br />
7 Charging Light<br />
8<br />
Battery<br />
Compartment<br />
9 Desiccant Cartridge<br />
10 Battery<br />
The large 8 line by 40 character (64 x 240 dots)<br />
Supertwist LCD (with a wide temperature range) presents<br />
status and data in a numeric or graphic format.<br />
Four rings at the side of the console that allow attachment<br />
of the carrying harness.<br />
Up to two sensor connectors may be present at the left<br />
hand side of the console. The nearer one J102, 10 Pin<br />
connector, is reserved for the magnetometer sensor.<br />
The J101, 8 Pin connector is reserved for the GPS<br />
antenna.<br />
The data output connector carries RS-232 data dump<br />
signals, as well as the analog signal for a strip chart<br />
recorder and is located at the right hand side of the<br />
console.<br />
It has the following pin assignments:<br />
A – common (ground) B – RS-232 receive data<br />
C – RS-232 transmit data C – analog out 0-1 Volt<br />
This connector accepts the charger to recharge either the<br />
standard battery or the external heavy-duty battery pack.<br />
It also accepts external, well filtered, 11 to 16 Volt DC<br />
input.<br />
The center pin is negative (-)<br />
The shell is positive (+)<br />
The charging light (visible through a window on the left<br />
side) indicates that the battery is charging at a high rate.<br />
The battery compartment is located at the back of the<br />
console and contains one rechargeable lead-acid battery,<br />
the desiccant cartridge and the fuse. The battery cover is<br />
replaced with another cover with a cable attached when<br />
the external battery is used.<br />
The desiccant cartridge is a cylindrical re-usable capsule<br />
filled with a drying agent. It absorbs any moisture that<br />
my get inside the instrument.<br />
A rechargeable lead-acid battery in the standard <strong>ENVI</strong> –<br />
MAG configuration.<br />
11 Fuse The standard 1.5A fuse to use with the standard battery.<br />
Keypad Description<br />
P/N 788715 Rev. 0