Release Bulletin NP V10.4.1R02 - Comtech EF Data
Release Bulletin NP V10.4.1R02 - Comtech EF Data
Release Bulletin NP V10.4.1R02 - Comtech EF Data
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Using this Document<br />
The following parameters have been added to the configuration of an Ethernet<br />
port for the redundant MAC and IP addresses:<br />
- Redundancy MAC address active (Configuration file: [iflan] RedunMacAddrActive;<br />
SNMP: iflanRedunMacAddressActive):<br />
YES: (default value) Allows for configuration of a redundant MAC address<br />
on this Ethernet port. This MAC address will be used as the source address<br />
instead of the default BIA or configured physical MAC address.<br />
Set this parameter to YES in a redundant system. This allows the two redundant<br />
units to have the same MAC address and be on the same LAN. The unit<br />
that is currently active is the one that uses the redundant MAC address.<br />
NO: (default value) A redundant MAC address is not available for this Ethernet<br />
port.<br />
- Redundancy MAC address (Configuration file: [iflan] RedunMacAddr;<br />
SNMP: iflanRedunMacAddress):<br />
Determines the redundant MAC address that the Ethernet port will use as<br />
source address when the unit is operating in a redundant system.<br />
1:1 Redundancy must be fully configured on the SDM-9620 (using SE/<br />
REDUNDANCY) for this parameter to take effect, including the unit Role,<br />
fault criteria, Backup name and remote unit identification.<br />
� Range of hexadecimal values: 00005E000000 to 00005E0000FF<br />
This range of MAC addresses is the Ethernet address block that the Internet<br />
Assigned Numbers Authority (IANA) has specified for unicast<br />
address assignments or other special purposes.<br />
� Default value: 00005E000000<br />
Caution: Be careful when configuring this parameter. With the<br />
exception of the redundant unit, the Redundancy MAC address<br />
must be different from the MAC address of other units on the same<br />
LAN if the other units can operate at the same time as the one you<br />
are configuring.<br />
- Redundancy IP address 1 (Configuration file: [iflan] RedunIpAddress1;<br />
SNMP: iflanRedunIpAddress1):<br />
Specifies the first redundant IP address that is activated by the Redundancy<br />
feature when the unit is operative.<br />
� IP address value: class A, class B or class C IP address in x.x.x.x<br />
format<br />
� Default value: 0.0.0.0<br />
- Redundancy subnet mask 1 (number of bits) (Configuration file: [iflan]<br />
SNRedunMask1; SNMP: iflanRedunSNMask1):<br />
3-16 Memotec Inc.