Release Bulletin NP V10.4.1R02 - Comtech EF Data

Bug Changes
Bug 4087 - FXS seizure detect time configuration
Bug Changes
Add an extended parameter allowing the change of the FXS seizure detect time. An
application like autodial could need a change of this parameter.
Console: EP VPORT p FXSSEIZUREDETECTTIME v, where p is the port number and
v is the value in ms
Range of value: 20 to 600
Default value: 50
Configuration file: [ifvce p] FxsSeizureDetectTime=v
CLI example: NP>EP VPORT 201 FXSSEIZUREDETECTTIME 50
EXTENDED PARAMETERS
VPORT 201> (FXSSEIZUREDETECTTIME) FXS seizure detect time (ms) 50
NP>
Bug 4097 - WarmStart and LinkStateInSync traps not sent
Resolve SNMP traps like WarmStart and LinkStateInSync not sent just following a unit
restart. At startup, the default gateway is often learned before all other routes learned by a
routing protocol. The default gateway could be used for the sending of the SNMP traps.
From 10.4.1 A12, the SNMP module will wait a minimum of 120 s before sending an
SNMP trap on the default gateway letting time to the router for learning routes.
Bug 4126 - Stuck in disconnect state with E&M Push-To-
Talk
Resolve a case where the answer side remains stuck in DISCONNECT state after a
shutdown of the WAN link in an E&M Push-To-Talk application.
Bug 4174 - E&M seizure detect time configuration
Add an extended parameter allowing the change of the E&M seizure detect time. An
application like redial could need a change of this parameter.
Console: EP VPORT p EMSEIZUREDETECTTIME v, where p is the port number and v
is the value in ms
Memotec Inc. 4-3