5pm cst SATURDAYS (April 11 - June 30)

Step 16
79
INSET A
79
48
H30
81
H158
3 1/4" - 3 3/8"
COUNTER-SUNK
HOLES SHOULD
BE UP
Swing Beam Assembly
*NOTE: Pre-drill all holes for Lag Bolts with the appropriate drill bit.
1. Attach Ground Runner (48) to Swing Beam Support Legs (79) using 3/8" Hardware (H3) (H116).
The bottom of the Ground Runner (48) should be flush with the bottoms of the Swing Beam
Support Legs (79) and the spacing between the Support Legs should be between 3 1/4" and 3 3/8"
(as shown in Inset A).
*NOTE: Ground Runner (48) must be square with the Swing Beam Support Legs (79).
2. Attach Swing Beam Support Legs (79) together with 3 1/4" PC Pipe (N4) using 3/8" Hardware (H3)
(H11) (H17) (H28) (H139). Tighten hardware until there is 3 1/8" between Swing Beam Support
Legs (79).
*NOTE: Support Wings (26) must be oriented in opposite directions before inserting 3/8"
Hardware (H30).
3. On a flat surface, insert 3/8" Hardware (H30) into pre-drilled holes in Support Wings (26) using a
hammer. Attach Support Wings (26) to Ground Runner (48) using 3/8" Hardware (H3) (H11) (H126).
4. Attach Support Wings (26) to Swing Beam Support Legs (79) using 1/4" Hardware (H1) and 5/16"
Hardware (H108).
5. Center Plaque (N23) on the Swing Beam (81) and attach using #10 Hardware (H158).
N23
H108
26
H1
H139
H3
35
N4
H3
H126
H11
H3
79
BOTTOMS
FLUSH
H1 H108
H28
H11
H17
H30
H3
26
H116
H126
H3
H11
48