PL1380 PL1381 PL1382 - Ufesa
PL1380 PL1381 PL1382 - Ufesa
PL1380 PL1381 PL1382 - Ufesa
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
IRONING WITH STEAM<br />
• Place the iron on the Iron-rest platform.<br />
• Gather up the mains supply connection cable<br />
After having carried out this operation, switch<br />
and insert it into the left-hand compartment. Fig. 8<br />
the appliance on.<br />
• Gather up the iron-boiler connection cable<br />
• Press push-button (8) on the iron to get a jet<br />
and insert it into the right-hand compartment.<br />
of steam. The steam stops as soon as the button<br />
Fig.8<br />
is released. Fig. 5.<br />
Use of steam below the 2 point "••" thermostat<br />
setting is not recommended.<br />
CREASE REMOVAL IN VERTICAL<br />
• Turn the temperature regulator (12) to the<br />
“MAX” position and wait until it reaches<br />
temperature.<br />
• Hang the garment on a hanger and place the<br />
iron some 10-20 cm away. Never iron a garment<br />
if somebody is wearing it at the time (Fig.6)<br />
• Press the steam production trigger for as long<br />
as considered necessary, a continuous jet of<br />
steam will be produced.<br />
STORING<br />
• Unplug the appliance<br />
• Wipe the sole plate down with a damp cloth<br />
while it is still warm, after each use.<br />
• It is not necessary to empty the boiler out after<br />
each use.<br />
MAINTENANCE AND CLEANING<br />
Avoid scratching the iron; do not pass it over<br />
hard surfaces. Traces of starch or sprays can be<br />
removed from the base with damp cotton wool<br />
or a non abrasive cleaning product.<br />
The boiler tank is made of stainless steel. Due to<br />
the characteristics of this material less lime scale<br />
is produced. It is advisable to rinse the boiler<br />
out regularly with clean water so as to remove<br />
any traces of lime, following the appliance’s<br />
safety rules; being unplugged and cold.<br />
The outer surface of both the iron and the boiler<br />
can be cleaned down with a damp cloth,<br />
without the use of abrasive agents or solvents.<br />
SAFETY DEVICES<br />
This appliance is fitted with the following safety<br />
devices:<br />
REPAIRS<br />
- On the iron<br />
• A safety trip that stops it from overheating<br />
- On the boiler:<br />
• A safety valve<br />
ADVICE ON DISPOSAL:<br />
• A safety trip that stops it from overheating.<br />
Should the cable and/or the appliance become<br />
defective do not hesitate in taking it to an<br />
Authorised Technical Service Centre.<br />
Our goods come in optimised packaging. This<br />
basically consists in using non-contaminating<br />
materials which should be handed over to the<br />
local waste disposal service as secondary raw<br />
materials. Your local town council can give you<br />
information about how to dispose of obsolete<br />
appliances.<br />
MOST COMMON PROBLEMS<br />
PROBLEM<br />
The iron does not<br />
heat up and the<br />
pilot lamp (11)<br />
does not come on<br />
Steam does not<br />
come out when the<br />
button (8) is pressed<br />
Water comes out of<br />
the holes on the<br />
iron’s sole plate<br />
when button (8) is<br />
pressed.<br />
CAUSES<br />
Switch (1) in the OFF position<br />
Thermostat control (12) set to minimum<br />
Problems with electric supply<br />
Boiler empty<br />
Switch (1) in the OFF position<br />
Thermostat control (12) set to minimum<br />
“•”<br />
Boiler tank is too full<br />
Boiler in a tilted position<br />
SOLUTION<br />
Press switch (1)<br />
Turn the thermostat control<br />
Check the electric wall<br />
sockets.<br />
Fill the boiler<br />
Press switch (1)<br />
Turn the thermostat control<br />
round to the steam position<br />
“•••”<br />
Remove some water<br />
Place it into a horizontal<br />
position.