1 Introduction to the 20FD Series Flat Panel TVs - Pioneer Electronics

05 Use Other Equipment With Your Flat Panel TV
108
En
5.9 HMG Setup
Use the HMG Setup option for Network Setup, Auto Connection Setup and Default Settings. For more information
about each option, refer to the following sections.
Network Setup
Select whether to acquire the IP Address automatically or manually or, when acquiring manually, set the IP
Address and Subnet mask. To access the Network Setup menu, follow the steps below.
Automatic:
To perform the procedure, DHCP on your server or router must be valid.
1 ) Press HMG.
The Home Media Gallery menu appears on screen.
2 ) Select HMG Setup from the menu.
Use the arrow buttons to highlight an option then press ENTER.
3 ) Select Network Setup.
4 ) Select Auto DHCP.
5 ) Select Yes.
The flat panel TV seeks and acquires an IP Address if available.
6 ) Press EXIT or HMG to exit Home Media Gallery.
Manual:
Before activating, check your media server for IP Address and Subnet mask information.
1 ) Access the Network Setup through the HMG Setup.
2 ) Select Auto DHCP.
3 ) Select No.
Network Setup
Auto Connection On
Default Settings
4 ) Select the appropriate box.
Use or to highlight an entry item (IP Address or Subnet mask) then press ENTER.
No need to enter Default Gateway and DNS Server data.
5 ) Enter the figures using buttons 0 to 9.
Subnet mask (such as 255.255.255.0): Enter the same figures.
IP Address (such as 192.168.201.***): Enter the same figures as used in the media server (PC, etc.). For
***, enter 3-digit figures (0 – 254) that have not been used for other network connections.
Use or to highlight other entry areas.
6 ) Press ENTER on the appropriate box after the entry is complete.
Repeat Steps 4 to 5 to complete Network setup.
7 ) Press EXIT or HMG to exit Home Media Gallery.