Sony HT-NT3 - HT-NT3 Mode d'emploi Anglais

[Audio DRC]
You can compress the dynamic range of
the sound track.
[Auto]: Automatically compresses
sound encoded in Dolby TrueHD.
[On]: The system reproduces the sound
track with the kind of dynamic range
that the recording engineer intended.
[Off]: No compression of dynamic
range.
[Attenuation settings - Analog]
Distortion may occur when you listen to
a device connected to the ANALOG IN
jack. You can prevent distortion by
attenuating the input level on the
system.
[On]: Attenuates the input level. The
output level will decrease at this setting.
[Off]: Normal input level. Select this
when connecting to a portable device
(such as digital media player).
[Audio Output]
You can select the output method
where the audio signal is output.
[Speaker]: Outputs sound from the
system’s speakers only.
[Speaker + HDMI]: Outputs sound from
the system’s speakers and 2-channel
linear PCM signals from the HDMI OUT
(ARC) jack.
[HDMI]: Outputs sound from the HDMI
OUT (ARC) jack only. Sound format
depends on the connected device.
Note
When [Control for HDMI] is set to [On]
(page 26), [Audio Output] is set to
[Speaker + HDMI] automatically and this
setting cannot be changed.
Audio signals are not output from the
HDMI OUT (ARC) jack when [Audio
Output] is set to [Speaker + HDMI] and
[HDMI1 Audio Input Mode] (page 26) is set
to [TV]. (Europe models only)
[Bluetooth Settings]
[Bluetooth Mode]
You can enjoy contents from remote
device by using this system or listen to
sound from this system by using other
device such as headphones.
[Receiver]: This system is in receiver
mode which enables it to receive and
output audio from the remote device.
[Transmitter]: This system is in
transmitter mode which enables it to
send audio to the BLUETOOTH receiver
(such as headphones).
[Off]: The BLUETOOTH power is turned
off and you cannot select the [Bluetooth
Audio] input.
Note
You can connect to a remote device by
using One-touch listening function even
though you have set [Bluetooth Mode] to
[Off].
[Device List]
Display a list of paired and detected
BLUETOOTH receivers when [Bluetooth
Mode] is set to [Transmitter] (page 24).
[Bluetooth Standby]
You can set the [Bluetooth Standby] so
that the system can be turned on by a
BLUETOOTH device even when the
system is in standby mode. This
function is only available when you set
[Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]: The system turns on automatically
when you establish a BLUETOOTH
connection from a paired BLUETOOTH
device.
[Off]: Off.
24 GB