Sony HT-NT3 - HT-NT3 Mode d'emploi Anglais

On placement
Leave the front of the system open.
Do not place the system on top of a
device that radiates heat.
Place the system in a location with
adequate ventilation to prevent heat
build-up in the system.
Do not place the Bar Speaker and
subwoofer on a soft surface (rugs,
blankets, etc.) or place anything at the
rear of the Bar Speaker and subwoofer
that might block the ventilation holes
and cause malfunctions.
Do not install the system near heat
sources such as radiators, air ducts, or
in a place subject to direct sunlight,
excessive dust, mechanical vibration,
or shock.
Do not install the system in an inclined
position. It is designed to be operated
in a horizontal position only.
Do not place metal objects in front of
the front panel. It may limit reception
of radio waves.
Do not place the system in a place
where medical equipment is in use. It
may cause a malfunction of medical
equipment.
If you use a pacemaker or other
medical device, consult your physician
or the manufacturer of your medical
device before using the wireless LAN
function.
Use caution when placing the Bar
Speaker and subwoofer on a surface
that has been specially treated (with
wax, oil, polish, etc.), as staining or
discoloration of the surface may
result.
Take care to avoid any possible injury
from the corners of the Bar Speaker
and subwoofer.
If the system is being used in
combination with a TV, VCR, or tape
deck, noise may result and picture
quality may suffer. In such a case,
place the system away from the TV,
VCR, or tape deck.
The speakers of this system are not
magnetically shielded.
Do not place magnetic cards or a CRTtype
TV set near the system.
On operation
Before connecting other devices, be
sure to turn off and unplug the system.
On adjusting volume
Do not turn up the volume while
listening to a section with very low level
inputs or no audio signals. If you do, the
speakers may be damaged when a peak
level section is suddenly played.
On cleaning
Clean the cabinet, panel, and controls
with a soft cloth slightly moistened with
a mild detergent solution. Do not use
any type of abrasive pad, scouring
powder or solvent such as alcohol or
benzine.
On replacement of parts
In the events that this system is
repaired, repaired parts may be retained
for reuse or recycling purposes.
On your TV’s color
If the system cause the color irregularity
on your TV screen, turn off the TV then
turn it on after 15 to 30 minutes. If color
irregularity persist, place the system
further away from the TV set.
IMPORTANT NOTICE
Caution: This system is capable of
holding a still video image or
on-screen display image on your TV
screen indefinitely. If you leave the
still video image or on-screen display
image displayed on your TV for an
extended period of time, you risk
permanent damage to your TV
screen. Plasma display panel
televisions and projection televisions
are susceptible to this.
Additional Information
39 GB