You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
_<strong><strong>MW</strong>E</strong>-<strong>1000</strong>-<strong>4FM</strong>.book Seite 43 Freitag, 5. August 2005 4:41 16<br />
magic watch Installing <strong>MAGIC</strong> <strong>WATCH</strong><br />
Connecting the power supply<br />
➤ Guide the connection cable (5 3, page 5) to the control electronics and<br />
plug the plug onto the connection on the control electronics (i, page 9).<br />
Make sure the locking pin catches.<br />
➤ Connect the red cable (h 3, page 8) on the control box to the positive<br />
wire (+) of the reversing light (h 2, page 8).<br />
➤ Connect the black cable (h 4, page 8) to the earth wire (-) of the<br />
reversing light or to earth (bodywork).<br />
Connecting the sensors<br />
The sensor plug polarities cannot be reversed: they can be only<br />
be plugged into the connection in one way.<br />
The arrow on the sensors must be visible on top.<br />
You must connect the sensors to the electronic controller as<br />
shown in the following table. Otherwise <strong>MAGIC</strong> <strong>WATCH</strong> will not be<br />
able to display the direction of the obstacles correctly.<br />
Connection in the<br />
Description<br />
electronic controller<br />
1 Outside right sensor (d 1, page 7)<br />
2 Inside right sensor (d 2, page 7)<br />
3 Inside left sensor (d 3, page 7)<br />
4 Outside left sensor (d 4, page 7)<br />
The sensors are numbered from 1 to 4. Connect the sensors to<br />
the appropriate connection in the control electronics.<br />
➤ Insert the plugs of the sensor cables into the corresponding sockets of the<br />
electronic controller (j, page 9).<br />
Make sure the locking pin catches.<br />
The “Buzzer” connection on the electronic controller remains free.<br />
43