pellets boiler - Paul Künzel GmbH & Co.

Abbildung 22: Disassembly of the fuse box
Abbildung 23: Fuse
open the ash–door and take out the burner–drawer, as described in chapter1.18.1 auf Seite 17.
Next, lift the burner–pipe [8] carefully, pull it to the left and then remove it from the boiler.
Subsequently, the end–piece of the down–pipe [7] should be taken out of the boiler. To do this, the
tightening screw needs to be loosened. The end–piece can now be pulled out from the down–pipe. Lift
out the burner–pipe overlay [10] from its position and remove it from the boiler. Then the burner overlay
[11] needs to be lifted out of place and taken out of the boiler in a forwards motion.
Finally, the ashtray should be taken out of the boiler. The remaining ash can be removed from the boiler
with a vacuum cleaner.
After a thorough cleaning around the burner area, all parts need to be reassembled in reverse order.
The pellet bin should be completely emptied during its half–yearly cleaning procedures. Any existing
automatic filling facilities are to be switched off. The wood–powder, which is to be found in the pellet–
bin, can be removed with the pellet bin–emptier [3] or with a vacuum cleaner.
During the half–yearly cleaning procedures, the fuse element must also be checked and cleaned. To do
this, loosen the tightening screw of the fuse box [6] and pull it through the hole in the fire pan and then
out of the burner–drawer.
After the service has been completed and the fuse element cleaned, the boiler has to be reassembled in
22