pellets boiler - Paul Künzel GmbH & Co.

Abbildung 2: Boiler and integrated pellet storage bin are transported separately
integrated pellet storage bin is detachable. In this way, it is also possible to carry the boiler down narrow
cellar steps.
When setting up, the local regulations and guidelines regarding installation in boiler rooms should be
observed.
Setting up the pellet boiler and the pellet storage must only take place in a dry, frost–proof authorized
room. A sufficient ventilation regulation in the boiler room has to be made sure.
For setting up the boiler, a level and adequately load–bearing floor is sufficient. If, however, a pedestal
has to be used, it should be the same size or slightly bigger than the boiler itself.
1.8 Separating the Boiler from the Integrated Pellet Bin
So that the KUENZEL Pellet Boiler can be carried more easily into rooms which are difficult to access,
one can separate the main body of the boiler from the pellet storage bin. This job can only be carried out
by two men.
To separate the integrated pellet bin from the boiler, these guidelines are to be followed:
1. Loosen the pellet supply flange screws as shown in the picture and put them aside.3 auf Seite 7
2. Loosen the screws at the four points of attachment as portrayed in picture ?? auf Seite ?? and put
them aside.
3. Now lower the pellet bin carefully from the flange.
6