UTP HydroCav - UTP Schweissmaterial

Standards :
DIN 8555 : MF 10-GF-60-GP
EN 14700 : T Fe8
MAG flux cored wire for tough-hard surfacings
against impact and abrasion
Application field
The metal powder flux cored wire SK 650-G is used for buildups on parts subject to compression, impact
and abrasion, such as cutting edges and working surfaces on cold and hot working tools, forging and trimming
dies, axial and planing rolls, rotors and beaters for mineral and stone crushing, teeth and scraper blades
of building machines, taper tools and shredder hammers.
Properties of the weld metal
Machining is possible by grinding or with tungstene carbide tools.
Hardness of the pure weld metal: 58 HRC
Weld metal analysis in %
C
0,45
SK 650-G
Welding instruction
Clean welding area to metallic bright. Preheat hot - and cold working tools to 400° C, stress relief, if necessary,
at 550° C. Use dragging or pushing welding technique in spray - or short arc with approx. 20 mm
wire stickout.
Welding procedure and availability
Ø
(mm)
Si
0,6
* available on request
Mn
0,9
Current type
Cr
5,5
Mo
1,4
Shielding gas
EN ISO 14175
V
1,0
Welding positions
W
1,6
Fe
balance
PA PB
Availability
Spools
M 21 C 1 EN ISO 544
1,2 DC (+) x x x
1,6 DC (+) x x x
2,4 * DC (+) x x x
147