ITech Centra Manual - ADSI
ITech Centra Manual - ADSI
ITech Centra Manual - ADSI
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
errors on the printer so you do not need to correct the skew point and scaling at the scale<br />
point.<br />
Origin Scale does alignment at the origin, rotation and x-axis only scaling at the scale<br />
point. It assumes that the scaling in the y-axis is correct. Normally you do not need to<br />
scan the Scale location because if you have a scaling error in your printer it is normally in<br />
the x axis and it is very consistent. If the printer you are using has a x axis scaling error<br />
you can normally correct this either in the printer or you can use calibrate to printer to get<br />
the <strong>Centra</strong> to cut the same size as the printer.<br />
5.4 Designing Labels<br />
5.4.1 Planning Label<br />
This tutorial will design a label for the<br />
Epson printer and <strong>Centra</strong> DFS with<br />
Illustrator and CorelDraw. It will<br />
show how to create a bleed area to<br />
minimize visual errors on the<br />
completed label. First we define our<br />
layout for a set of four 3x5 labels so<br />
we can create a set of locations in the<br />
artwork generation program<br />
workspace. We lay out the frame with<br />
the x axis (media movement going up<br />
and down on the screen and the y axis<br />
(operator/front to gear/back). The<br />
target in this orientation appears in the<br />
upper left corner of the screen. This<br />
allows for no rotation when the<br />
sending the job to the printer.<br />
Then add the target<br />
Then add 0.50 bleed on one label<br />
So we need horizontal locations at:<br />
0 , 5, 5.25, 5.3, 10, 10.2, and 10.25<br />
and vertical locations at<br />
-0.5, -0.25, 0, 0.05, 2.95, 3, 3.25, 6.25<br />
Add one to vertical so they are all positive numbers<br />
0.5, 0.75, 1, 1.05, 3.95, 4, 4.25, 7.25<br />
14